Manual

Set up your remote to operate other IR controlled brand name devices.
VCRs,Cable Boxes, TVs, Satellite Receivers, DVD Players, Audio CD Players, Audio Tape Decks,
Audio Tuners and Amplifiers etc. See listing on pages 42/43
Turn on the device you want to program,
On the chart on page 42/43, find the type of device you're
programming, and then find the brand name, Make a note of
the three-number code, you'll need it soon,
Press and hold PRG, It's recessed so it doesn't get pushed
accidentally, Use a small, blunt object, When the indicator
light turns on, you can release PRG,
Push the key name with the type of device you're program-
ming (VCR,CABLE,AUX,TV),
Using the NUMBER keypad, enter the three-number code you
found on page 42/43.
Press ENTERto save the code. (The indicator light will flash
3 times, then turn off to indicate the code is valid.)
Point the remote at the device and push POWER, It should
turn off, If not, try the other codes listed and continue from
step three,
Note: To reset remote to factory settings, enter 9-1-1, in
Step 5,
Note: After programming, be sure to press the mode key
first to operate the device you havejust programmed,
Programming your Zenith remote may allow .you to use one remote
to work up to 7 different devices.
Not all devices will work with your Zenith remote control.
PROGRAMMING
PRG
DEVICE
Procedure to set up remote to operate other equipment.
Programming mode key.
Infra-red remote controllable electronic accessory equipment.
P A G E 3 8 2o6-38o3