Operating instructions

Operation Operation
19
ENGLISH
About the button names in this explanation
<>
: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
[MODE SELECTOR 2]
FUNCTION
[MODE SELECTOR 1]
[ZONE3 ON]
[D]
[A]
FUNCTION
[NUMBER]
( 0 ~ 9, +10)
[ZONE2 OFF]
[ZONE2 ON]
FUNCTION
<POWER>
<ZONE/REC SELECT>
<SPEAKER>
ENGLISH
¢ Last function memory
The various settings set when the DRA-397’s power is switched to
standby are stored in the memory. When the power is turned back on,
the settings made when the power was switched to standby are
recalled.
About the memory functions
¢ Backup memory
The various settings are stored in the memory for about 1 week, even
when the power is turned off or the power cord is unplugged.
Initialization of the microprocessor
If the indication on the display is not normal or if the operation of the
unit is not correct, then the microprocessor should be reset by the
following procedure.
Switch off the unit using
<
POWER
>
.
1
Check that the entire display is flashing at 1-second
intervals and release the buttons.
• The microprocessor will be initialized.
3
Keep both
<
SPEAKER
>
(A and B) depressed and turn
on the unit by pressing
<
POWER
>
.
2
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from the
factory).
Recording (audio and/or video)
Press
<
ZONE/REC SELECT
>
until “RECOUT”
appears on the display.
Use FUNCTION to select the source to be recorded
(audio and/or video).
• The “ ” indicator lights.
1
2
•To cancel, press
<
ZONE/REC SELECT
>
and set the function to “ZONE”.
RECOUT
M-ZONE
Record (the audio or video signals).
For operations, see the operating instructions of the device from
which you are recording (audio or video signals).
3
NOTE:
• When the REC OUT mode is selected, [ZONE2 (ZONE3) ON] and
FUNCTION (ZONE) cannot be operated.