Service manual

PV152 2-6 PROJO
SERVICE ADJUSTMENTS ORDER
SERVICE MENUES CONT.
ITEM SETTING RANGE DESCRIPTION
P17 ZP94/95 *Non-Adjustable Data
TA1298
BSP 03 00-07 Black Strech Point
APL/BS 00 00-03 APL / Black Strech Point
B COR 01 00-01 Black Level Correction
B GA 00 00-01 Black Strech Gain
B DET 00 00-01 Black Detect Level
DABL PN 00 00-07 Dynamic ABL Detection Point
DABL GA 07 00-07 Dynamic ABL Gain
ABL PN 07 00-07 ABL Detection Point
ABL GA 05 00-07 ABL Gain
P18 ZP94/95
V CHIP RATING
POLLING 0F 00-0F 0
TIMEOUT 05 00-0F 0
STATUS 02 00-0F 0
AFC/CLOCK TEST
Order Adjustment Item Screen Format Signal DCU Data
Pre HEAT N/A NTSC N/A
1 Cut Off Progressive NTSC
2 Pre Focus Lens and Static Progressive NTSC
3 DCU Phase Data Setting Progressive NTSC
4 DCU Phase Data Setting HD 2.14H
5 Horz. Position Adj. (Coarse) Progressive NTSC
6 Horz. Position Adj. (Coarse) HD 2.14H
7 Raster Tilt Progressive NTSC CLEAR
8 Beam Alignment Progressive NTSC
9 Raster Position Progressive NTSC CLEAR
Horz. Size Adjust Progressive NTSC CLEAR
Horz. Size Adjust HD 2.14 CLEAR
11 Vertical Size Adjust Progressive NTSC CLEAR
12 Beam Form Progressive NTSC
13 Lens Focus Adjust Progressive NTSC
14 Static Focus Adjust Progressive NTSC
15 Blue Defocus Progressive NTSC
16 White Balance Adjustment Progressive NTSC
17 Sub Brightness Adjustment Progressive NTSC Color Bar
18 Horz. Position Adjustment Progressive NTSC
19 Horz. Position Adjustment HD 2.14H
20 Convergence Alignment Progressive NTSC
CLEAR to start
21 Convergence Alignment HD 2.14H
ZP 94/95 SERVICE ADJUSTMENT ORDER “PREHEAT BEFORE BEGINNING”
It is necessary to follow the order when performing an alignment on the ZP 94/95 chassis.
10
SERVICE ADJUSTMENT PROCEDURE ORDER
The following is the suggested order for adjustment
procedures.