Service manual

PV151 1-1 PROJO

CAUTIONS WHEN CONNECTING / DISCONNECTING THE HV CONNECTOR

Perform the following when the HV connector (anode

connector) is removed or inserted for CPT replacement,

etc.

During Removal

1. Roll out silicon cover from FBT’s contact area slowly.

2. While turning the connector about 90 degrees following the arrow

(0 position). Push the connector slightly toward the case. (Fig. A)

During Insertion

1. Please refer to direction for insertion as shown in Fig. B (L position).

Insert connector until “CLICK” sound is heard.

2. Make sure the connector is pressed right in, so that it has a good

contact with the spring.

3. Confirm the contact by pulling the connector slightly. (Don’t pull

hard because it may damage the connector).

4. Cover the high voltage output by carefully pushing silicon boot

onto it. (Don’t turn the connector).

Note: Make sure the silicon boot is covering the high

voltage output.

FIG. A

PUSH

HV Cable

FlybackTAB

POSITION

FIG. B

Flyback

HV Cable &

Boot Assembly

LESS THAN 1mm

DEFLECTION

P.W.B

FBT

ANODE

CONNECTOR

3. Remove the connector slowly by pulling it away from the case.