Instruction manual

OPERATION I PAGE Z7
This page shows a typical video system and explains howto select channels.
All-Channel,
Antenfla
Cable 1"€
W_k-- Direct £ab_ Or
),_-
CableBox
Cable- TV IN OUT
H CH4 Cab_ Box
System_ _ (
Output
to VCR
Zenith TV
ZenithStereoVCR
I CHANNEL13_]4
I 0_'I_ I VCROutput to W
AUDIOVIDEO (Channel3or4when
VH F/U HE/DAle/ OUT OUT VCRis on and _//_CR
VHF-UHF
C_E IN
VIDEO AUDIO
IN IN
SeLecting Channels when the VCR is OFF
1. TurnTVon.
2. Select channel you'd like to watch at the TV. If you have
a cable box, select channel 3 or 4 at the TV. Select cable
box channels at the cable box.
Selecting Channels at the TV when VCRis ON
1. TurnTVandVCRon.
2. Place VCRin W mode by pressing the TV/VCR button on
the remote control repeatedly until the VCRindicator
disappearsfrom thefrontpanelofthe VCR.
3. Select channel you'd Liketo watch at the 1V. If you have
a cable box, select channel 3 or 4 at the TV.Select cable
box channels at the cable box.
Selecting Channels at the VCR when VCRIs ON
1. TurnTVandVCRon.
2. Place VCR inVCR mode by pressingthe TV/VCR buttonon
the remotecontrolrepeatedlyuntilthe VCR indicator
appearsin the frontpanelofthe VCR.
3. Select channels 3 or 4 at the TV. If your TV Lsequipped
with A/V input jacks, check your TV operating manual to
select A/V source for a better picture.
4. Select the channel you'd Liketo watch at the VCR. If you
have a cablebox,selectchannel3 or4 atthe VCR.
Selectcablebox channelsatthe cablebox.