Instruction manual

Some quick and easy tips to fixing problems yourself.
TROUBLESHOOTING I PAGE 37
Channel Tuning ProbLems
Observed CondiUon
Some channels are skipped over when
using CH (V/A).
Picture and soundare weak or missing.
PossibLe Cause
Those channels were deleted with the
CH. ADD/DEL option.
Antenna or cables are Loose.
Wrong SOURCEoption is being used.
Probable Solution
Use CH. ADD/DELto restore channels.
See SETUPMenuon page 25 for details.
Tighten connections or replace cabLe.
TryaLLSOURCEoptions. See SETUP
menu on page 25 for details.
RecordingProbLems
ObservedCondition PossibLeCause
Camcorderimageis not shown. Camcorderis off.
Camcorderimagevia A/V input to VCR
is not shownonTVscreen.
Timerrecordingis not possibLe.
TLMERindicatorUghtappearsafterVCR
is turnedoff.
VCRSOURCEis not set to AUX.
CLockin VCR is not set to correct Ume.
VCRis on which disables timer.
Timer has been programmed
incorrectly.
TIMER indicator Lightdoes not appear
after programmingtimer.
VCRis in Timer Recording mode.
Probable Solution
Turncamcorderon and operate
properLy.
UseCH (V/A) to selectAUXA/V
mputchanneL.
Setclockto correctUme.SeeCLOCK
menuonpage23.
TurnVCRoff to enabletimer. TIMER
indicator Lightappearsin the VCRfront
_anel.
ReprogramTimer.SeeTIMERmenuon
page24.
ReprogramTimerandturn VCRoff to
enabletimer.
Thisis the normalindication that the
VCRis in TIMERmode.
VCR Plus+®C' Recording ProbLems
Observed Condition Possible Cause Probable SoLuUon
VCRrecords program on different chart- Channel Mapping was not performed or Channel map the VCRfor your area.
ne[ than channeL specified, is incorrect. See "Setup for VCRPLus+®C3 Recording"
section.
VCR does not control cable box.Recordedwrong channel or no channel
with cab[e box.
CabLebox is not tuned to channel you
wanted to record.
CabLebox is not turned on.
VCRis not tuned to cable box output
channel 3 or 4.
Useproper'MFR'numberfor cable box.
See"Setupfor VCRPLus+®C3 Recording"
section.
Tune cable box to channeLyou want to
record. Keep cabLebox turned on.
Turn on cable box and keep it on.
Tune VCRto cable box output channeL.