Operating instructions

9200668-02
ENGLISH
RAINTIGHT
OUTDOOR USE ONLY.
FOR WALL AND CEILING MOUNT ONLY
SUITABLE FOR WET LOCATION
MADE IN CHINA
THIS END UP
�
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow xture to cool before touching. The bulb and the xture
operate at high temperatures.
• Keep xture at least 2" (51 mm) from combustible materials.
Do not aim at objects closer than 3' (1 m).
• Replacement Bulb - Use only T4 100W (max.), G8 tungsten
halogen bi-pin 120 VAC bulbs.
CAUTION: Keep the sensor at least 2" (51 mm) away
from the bulbs.
Junction box ground wire to green
groundscrewonxture.
Wiring Floodlight
White to WhiteBlack to Black
Gasket
Mounting Strap
YELLOW Antenna Wire Placement Options
(Ensure wire is straight)
Mounting
Bolt
Rubber Plug
HALOGEN FLOODLIGHT
Features and Ratings:
• Up to 200 Watt Maximum Tung-
sten Halogen (Up to 100 Watt
Maximum each bulb holder.)
• Minimal wiring required.
• Installxtureinaccordancewithlocalcodes.
Installation
1. Remove the existing light xture.
2. Install the mounting strap as shown using two screws that t
your junction box.
Note: The plastic hanger can be used to hold the xture while
wiring. Thread the small end of the plastic hanger through the
hole in the center of the cover plate. Insert the small end into
one of the slots on the mounting strap.
3. Route the wires from the light receiver through the large gasket
holes.
4. Twist the junction box wires and xture wires together as shown.
Secure with UL approved wire connectors.
IMPORTANT: Do NOT cut any wires connected with a
factory installed wire connector.
5. For best performance, the yellow antenna wire needs to be
installed as straight as possible inside the wall or eave cavity.
Placement possibilities include:
• Placing into the junction box and through a hole that does
not have electrical wiring running through it.
• Push the antenna between the junction box and the wall so
that it hangs down inside the wall.
IMPORTANT: The communication distance of the product is
directly affected by metal surfaces and electrical interference.
Stucco, aluminum siding, metal junction boxes, and electrical
wiring may block the ability of the antenna to receive a clear
signal.
WARNING: Turn power off at the fuse or circuit
breaker.
Continued
6. Align the cover plate and cover plate gasket. Secure with
mounting bolt.
7. Push the rubber plug rmly into place.
8. Not intended for waterproof junction boxes. Fixture should be
surface mount only. Caulk the wall plate mounting surface with
silicone weather sealant.
Exterior Wall or Eave
Inside the Wall or Eave Cavity
Junction Box