Owner`s manual

Troubleshooting
Before calling for service, please check the following symptoms/solutions.
You may be able to avoid a service call.
Symptom Cause Solution Page
Operation indicator -Power Cable is loose. • Tighten power cable securely to projector 25
does not light. and power outlet.
Projected image -Lamp is about to fail. • Contact service center to replace lamp. 13
gets darker or
deteriorates.
Temperature -Cooling fan not working. • Contact service center. 13, 43
indicator is red. -Internal circuits damaged. • Contact service center.
-Air filter clogged. • Clean air filter.
-Room is hot. • Cool off room.
No image -Power off. • Turn power on. 15 - 23
appears on-screen. -Lens cap on. • Remove lens cap.
-Source not selected/off. • Select correct source, turn source on.
-Unit warming up. • Lamp at full power after 40 seconds.
Menu will not appear. -Source not connected. • Connect source. 15 - 22, 27
“NO SIGNAL” -Source not connected. • Connect source. 15 - 22, 27
message appears. -Source not sending • Check all connections.
out a signal. • Check source operation.
“OUT OF RANGE” -Not a supported format. • Change to supported format. 42
message appears. • Change format of source signal output.
No sound. -Volume level too low. • Increase sound level. 15 - 23
-Connection problem. • Connect cables securely.
Image color is wrong. -Incorrect color balance. • Adjust color balance. 41
-Wrong video settings. • Adjust Video menu options.
Blurred or out of -Out of focus or position. • Focus and position image on screen. 23 - 24
focus image. -Tracking wrong. • Adjust tracking. 39
-Lens dirty. • Clean lens, see maintenance. 43
44
INFORMATION