Manual

SETUP MENU
> AUTO CH, SF_ARCtt'_
CH. ADD/DEL |
TUNING BAND |
AUTO FINE TUNE[
CLOCK SET i
CAPTIONS ..,}
I
I I
i i 1
AUTO CH. SEARCH CH2
ADDED
PRE_KSADJUST PRESS ADJUST
KEY TO START KEY TO CHANG E
Auto Ch. Search Ch. Add/Dei Display
Display
I
i 1
PRESS ADJUST
KEY TO CHANGE
Captions Display
I
< 1
TUNING BAND
BROADCAST
PRESS ,M)JUST
KEY TO CHANGE
Tuning Band Display
I CLOCK SET
PRESS NUMBERS
OR ADJUST KEYS
J
Clock Set Display
I
PRESS .ADJUST
KEY TO CHANGE
Awto FiineTune
Display
AUTO CH. (Channel) SEARCH
Purpose
Finds "allavailable channels and stores them in memory for
access by CHANNEL (CH) Up/Down.
Use AUTO CH. SEARCH only when you first install your
TV, or when you permanently change the connections to
the TV. For example, when you replace the antenna with a
cable-TV system.
Programmed channels are stored in protected memory, and
are not affected by a power outage.
- > AI._O CH. SEARCH
CH. ADD/DEL
TUNING BAND
AUtO FINETUNE
CT_OCK SET
C,AFHONS
_-..._...___
Selecting Auto Ch.
SEARCHING FOR CHANNELS
While Searching for
Active Channels
2373-A
=======._
AUTO CH. SEARCH
PRESS ADJUST
KEY TO START
Auto Ch. Search Display
f ',
AUTO CH. SEARCH HAS COMPLEIED
TUNING BAND IS
-"--]CHANNELS FOUND
When Search is
Complete
Before Using AUTO CIt. SEARCH
Connect ;and turn ON all external equipment, such as cable
TV decoder, VCR, etc.
To Use AUTO SEARCH
1. AUTO CH. SEARCH display should be shown on
the TV if you followed the "Basic: Menu Operation"
given in the "On-Screen Menus" section.
2. Press ADJUST (ADJ) Left/Right to start the
AUTO CH. SEARCH, the status of the search is
shown in the display. When the search is complete,
you can watch the TV program of your choice.
When Some Channels A_ Not Found
AUTO CH. SEARCH flaldsonly active channe,ls and stores
them in the favorite channel[ memory. You can add channels to
those stored in memory by using the CH. ,4J)D/DEL option.
If you have difficulty tunktg some channels, you may have to
manually change the TUNING BAND _mdAUTO FINE
TUNE. Refer Io respective option for details.
When Oaly AU2KChannel[ Is Found
You may have used AUT() CH. SEARCH without having a
signal source (antenna, cable-TV, etc...) connected to the TV.
In which case, no channels are stored in the favorite channel
memory, ;andthe TV operates only on the AUX channel
To resolve this conditiott, connect a signal source, turn signal
source ON, if needed, and use AUTO CFI. SEARCH again.
NOTE: AUX (Auxiliar2j) channel is operatio_ml only on TVs
having separate video ard audio inputs for VCR operations.
9-1