Manual

SETUP MENU
AUTO FINE TUNE
Purpose
Lets your TV compensate for variations in broadcast and
cable-TV frequencies.
If you are having difficulty tuning channels, the AUTO
FINE TUNE may have to be set manually to match your
viewing needs.
Before Using AUTO FINE TUNE
Connect and turn ON all external equipment, such as cable-
TV decoder, VCR, etc.
NOTE: AUTO FINE TUNE is not displayed while AUX
channel is being used.
f
AUTO CH. SEARCH
CH. ADD/DEL
TUNING BAND
- > AUTO FINE TUNE
CLOCK SET
CAPTIONS
AUTO FINE TUNE
FIXED
PRESS ADJUST
KEY TO CHANGE
To Use AUTO FINE TUNE
1. AUTO FINE TUNE display shouht be shown on the
TV if you followed the "Basic Menu Operation"
given in the "On-Screen Menus" section.
2. Press ADJUST (ADJ) Left/Right to select the
desired mode of operation, as follows:
• FIXED is used to receive "over-the-air" TV stations,
and with many cable TV systems.
• SEARCH is used only when the TV must search to
f'm(l the frequency being received, such as when used
with certain VCRs and video game controllers.
When Some Channels Are Not Clear
If some channels are not clear, change the TURNING
BAND. You may have to try different AUTO FINE TUNE
and TUNING BAND se_tings until you get a ,consistently
clear picture, charmel-to--channel. Refer to the TUNING
BAND option for details.
Selecting Auto Fine Tune
Auto Fine Tune Display
CLOCK SET
Purpose
Sets the clock in the TV to the correct time.
After the time has been set, the current time will appear on
the Channel/Time display whenever the TV is turned on,
the channel is changed, or ENTER (ENT) is pressed.
Power Failure Note: The time will have to be reset if power
to the TV is interrupted.
AUTO CH.SEARCH
CH.ADD/DEL
TUNING BAND
AUTO FINETUNE
- > CLOCKSET
CAFFIONS
Selecting Clock Set
f
CLOCK SET
P_RE_ NUMBERS
OR ADJUST KEYS
Clock Set Display
To Use CLOCK SET from Remote Control
1. CLOCK SET display should be shown on the TV if
you followed the "Basic Menu Operation" given in
the "On-Screen Menus" section.
2. Use the numbered buttons on the remote control to
enter the current time. Press ENTER (ENT) to start
the clock.
For example, to set the clock to 6:30, press 6, then
3, then 0; and then press ENTER (ENT). If you
enter an invalid time, such as 14:35 or 2:80, the time
will disappear and you can enter another time.
To Use CLOCK SET from Control Panel
1. CLOCK SET display should be shown on the TV if
you followed the "Basic Menu Operation" given in
the "On-Screen Menus" section.
2. Use ADJUST (ADJ) Left/Right toset the time, and
then press ENTER (ENT) to starll the clock.
ZS_A 9 -- 3