Owner`s manual

2. PRECAUTIONS REGARDING INSTALLATION LOCATION
This product is an indoor game machine. Do not install it outside. Even indoors, avoid installing in places mentioned below so as
not to cause a fi re, electric shock, injury and/or malfunction.
- Places subject to rain or water leakage, or places subject to high humidity in the proximity of an indoor swimming pool and or
shower, etc.
- Places subject to direct sunlight, or places subject to high temperatures in the proximity of heating units, etc.
- Places fi lled with infl ammable gas or vicinity of highly infl ammable/volatile chemicals or hazardous matter.
- Dusty places.
- Sloped surfaces.
- Places subject to any type of violent impact.
- Vicinity of anti-disaster facilities such as fi re exits and fi re extinguishers.
- The operating (ambient) temperature range is from 41F
o
to 86F
o
.
2-1 LIMITATIONS OF USAGE
Be sure to check the Electrical Specifi cations. Ensure that this product is compatible with the location’s power supply, voltage and frequency
requirements. A plate describing Electrical Specifi cations is attached to the product. Non-compliance with the Electrical Specifi cations can
cause a fi re and electric shock.
This product requires a breaker and earth mechanism as part of the location facilities. Using the product without these can cause a fi re and
electric shock.
Ensure that the indoor wiring for the power supply is rated at 5A or higher (AC single phase 100V~120V area), and 7A or higher (AC
220V~240V area). Non-compliance with the Electrical Specifi cations can cause a fi re and electric shock.
Be sure to use an independent power supply equipped with a surge-suppressor. Using a power supply without a surge-suppressor can cause
an outbreak of fi re if a power surge occurs.
Putting many loads on one electrical outlet can cause generation of heat and a fi re resulting from overload.
When using an extension cord, ensure that the cord is rated at 15A or higher (AC 100V~120V area) and 7A or higher (AC 220V~240V
area). Using a cord rated lower than the specifi ed rating can cause a fi re and electric shock.
2-2 OPERATION AREA
For the operation of this machine, secure a minimum area of 2.6m (8.6F) (W) x 3.0m (9.8F) (D) for 52”/62”DX cabinets, 2.14m (7F) (W) x
2.5m (8.2F) (D) for 29”STD cabinet. In order to prevent injury resulting from falls/accidents during game play, be sure to secure the mini-
mum area for operation.
Be sure to provide suffi cient space (200mm = 7.9” minimum) so as to allow this product’s ventilation fan to function effi ciently. To avoid
machine malfunctions or fi res, do not place any obstacles near the ventilation opening.
Do not allow objects to block the ventilation ports. It can cause generation of heat and a fi re.
SEGA shall not be held responsible for damage or compensation for damage to a third party, resulting from the failure to observe this
instruction.
In order to transport the machine into a building, the minimum necessary dimensions of the opening (of doors, etc.) are 1.3m (4.3F) [W] and
1.9m (6.2F) [H].
Ventilation space:
200 mm (7.9") minimum
3000 mm
(9.8F)
2600 mm (8.6F)
FIG.2
Ventilation space:
200 mm (7.9") minimum
2500 mm
(8.2F)
2134 mm (7F)
52"/62"DX
29"STD
*Picture is 62"DX
Electricity Comsumption: 52”/62”DX
960W, 8A (AC 120V, 60Hz)
Electricity Comsumption: 29”STD
600W, 5A (AC120V, 60Hz)
3