Instructions / Assembly

Step 4

Once the Trim Puller is wedged

between the trim and the wall

gently pry the trim away from the

wall creating a gap of approximately

4” to 8”. Repeat Steps 2 – 4

moving the Trim Puller along the

wall in 12” increments or as needed.

The gap in Step 4 will increase with

each pull until removed.

Step 3

Strike top of Trim Puller with

hammer or hard mallet driving the

Trim Puller between the trim and

the wall. The wedge will begin to

separate the trim from the wall.

Step 2

Position Trim Puller’s front face

against the wall with the sharp

edge on the seam where trim

meets the wall. For best results

start at the end of baseboard strip.

Step 1

Use a utility knife or painters 5-in1

tool to score top of seam where trim

meets the wall.

IT S AMAZINGLY EASY!

No shim or small board spacer needed

’

PAGE 1
IT’S AMAZINGLY EASY! No shim or small board spacer needed Step 1 Step 2 Step 3 Step 4 Use a utility knife or painters 5-in1 tool to score top of seam where trim meets the wall. Position Trim Puller’s front face against the wall with the sharp edge on the seam where trim meets the wall. For best results start at the end of baseboard strip. Strike top of Trim Puller with hammer or hard mallet driving the Trim Puller between the trim and the wall. The wedge will begin to separate the trim from the wall.