Operation Manual

ZENNiOAVANCEYTECNOLOGÍA www.zennio.com



TYPE Æ Select the control type to use:

¾ On/Off:

This is the most basic control type; Turn On/Off;

pretends to simulate a common switch action.

¾ On/Off + Simple Regulation (4 bits):

Users can simulate a

common switch action, turn On/Off (short press on the

buttons), or a discreet regulation (long press on the buttons),

where depending on the “dimming step” set, keeping the

button pressed will reduce or increase the brightness on the

controlled lamps.

• Dimming Step: Six different regulation levels are

available for this duty. A long press on the display

buttons will reduce or increase the brightness level step

by step the percentage set in this parameter; once the

desired level is reached, stop pressing the button on the

display to keep the desired value.

Dimming Step Necessary button presses for a

complete regulation (0 – 100%)

6. 100% 1

5. 50% 2

4. 25% 4

3. 12.5% 8

2. 6.25% 16

1. 3.1% 32

0. 1.5% 64

• Indicator:

This will inform users about the brightness

percentage applied at any time.

Note: In this case, for this indicator to be

functional, it is necessary to use a KNX

dimmer to give back the brightness applied to

the load.

¾ Precise Dimming (1 byte): This is the most accurate control

method, as any short press on the display buttons will increase

or reduce (1%) the brightness level.

A long press on any of the two buttons will increase or reduce

gradually 10 % the brightness level.