Operation Manual

ZENNiOAVANCEYTECNOLOGÍA www.zennio.com

23
This function consists on the cyclical sending of “0” & “1” while
activated. A random semi-cycle duration is applied for the ON/OFF
within the parameterized limits.
Note: This simulation can be enabled / disabled through the
display or through an object; and once activated; this will only be
running during the parameterized time range.
STARTING TIME / FINISH TIMEÆ This parameter adjusts the
time for the daily simulation to start/stop running (once enabled the
function).

¾ Max/Min ON/OFF time
: Users can adjust by parameter the
minimum and maximum ON/OFF time for the devices on the
installation.
2.2.2. “SPECIFIC” PAGES
The InZennio Z38 has three specific pages to configure:
Available options are:
¾ SCENES (5 boxes available)
¾ SCHEDULE PROGRAMMING (4 boxes available)
¾ CLIMATE (5 boxes available)
To enable these pages, just go to the Main Menu <<PAGES>> when “Editing
Parameters”.
2.2.2.1. SCENES
The way to parameterize a “Specific Page” to control scenes, is exactly
the same as that described in section “2.2.1.6 SCENE CONTROL”;
please refer to this section to obtain detailed information on this topic.
2.2.2.2. SCHEDULE PROGRAMMING
The daily/weekly programming of certain events the user wants them to
happen on the KNX installation is much easier using this Page.