Operation Manual
ZENNiOAVANCEYTECNOLOGÍA www.zennio.com
35
Note: When an error or accident is detected on the KNX installation, InZennio
Z38 will show the “Technical Alarms Screen”, and a danger icon will appear in
the box affected; at the same time, the Panel blinks and emits a “beep” to warn
the user.
Once the warning reception is confirmed by the user (pressing the OK button),
the screen will recover its normal state:
After 90 seconds, Inzennio Z38 display will again show the “Home” default
screen.
It is Really Important to know that confirming a warning doesn’t make the
Danger icon disappear from the box affected; this icon will only disappear from
the screen when the detector device sends again to the BUS its “normal status”;
if cyclical monitoring is enabled, it will be the own device which sends this
status when danger disappears.
2.2.4. CONFIGURATION
This is a specific page where to adjust some basic parameters.
Every “enabled” Box in the display has a field “Name”:
NAME Æ This field allows a user to associate a name with the
corresponding box in the display, (11 free characters are available to set
the name).
BOX 1 (Programming Mode)
When programming a device physical address, users can set the
“Programming Mode” directly from this box. This characteristic
makes this process easier as the user won’t need to access the rear
side of the panel to push the “Programming Button” any more
BOX 2 (Time Setting)
To set the time on the display:
¾ Time (together with the room temperature) is always displayed
in the middle upper section of the display.
¾ When setting the time, the display will send the new settings to
the BUS through its own Communication Objects.
¾ The refresh rate is 1 minute.
¾ When the display recovers from a BUS Power failure, this will
show the time it had just before the incident.