Operation Manual

ZENNiOAVANCEYTECNOLOGÍA www.zennio.com

39
¾ Raise/Lower Switching: Alternative switching between the
Pull Up/Down orders (to manage the shutter with an only
input).
¾ Stop/Pull Up Step:
Stops the shutter. When talking about
shutters with lamellas, this mode allows the user to control
them; this parameter moves lamellas a pull up step. The BUS
receives a “0”.
¾ Stop/Pull Down Step:
Stops the shutter; when talking about
shutters with lamellas, this mode allows the user to control
them; this parameter moves lamellas a pull down step. The
BUS receives a “1”.
¾ Stop/Step Switching:
Stops the shutter; when talking about
shutters with lamellas, this mode allows the user to control
them; this parameter alternatively switches the lamellas pull up
and down steps.
Note I:
When no directional lamellas are present, any of the 3 last
options will “stop” the shutter.
Note II:
Este último modo "parar persiana" incluye las 3 opciones de
paso arriba, paso abajo y paso conmutado para el control de lamas;
pero si la persiana no dispone de lamas orientables, cualquiera de las 3
opciones serviría para realizar la función parada de la persiana.
Note III:
Si se elige la función “subir/bajar” para la pulsación corta, no
se podrá realizar la función “parar persiana” en cualquier punto del
recorrido con otra pulsación corta de la misma entrada.
2.3.1.3. DIMMER CONTROL
This function results on sending a (4 bits) Dimming Control Object to
the BUS.
Dimming is typically quantified using percentages, such as 10%
dimming, and usually refers to the reduction in measured lumen output.
Therefore, a 100-lumen light source in a 10% dimmed system would
produce 10 lumens.
RESPONSE Æ Depending on the chosen option, the Control Object
may be:

¾ Light ON:
Turn the light ON. “The BUS receives a “1”.
¾ Light OFF:
Turn the light OFF. “The BUS receives a “0”.
¾ Light ON/OFF (toggle):
Alternative switching between the
ON/OFF orders (to manage the lighting level with an only
input).