Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA
13
Figure 3.4. Touch blocking
Initial updating This functionality allows re-establishing the value of the general
indicators (if enabled by parameter) as well as the values of the 1-bit objects associated to the
buttons, after a power failure. Moreover, this functionality allows establishing a delay for
sending the initial values since the power is recovered.
Note: If this function is not enabled, the values prior to the bus power failure will be kept.
Remote control. When enabling ("Yes") this optin in the general screen, the operation of
the remote control will be activated and the following features can be configured:
 Special function 1 (F1): configurable for sending the value "1", "0" or switching
betrweem them when the button F1 of the remote control is pressed. It will be appear a
new 1-bit communication object: "[IR] F1".
 Special Function (F2): same working as F1, but this time, when pressing the button
F2 in the remote control. The 1-bit object "[IR] F2" will be enabled.
 IR Blocking: the remote control blocking is configured in the box "Touch blocking",
already seen, since it can be only blocked with the touch panel altogether.
Figure 3.5. Remote control