Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA

Internal Temp. Sensor. ZAS has an internal temperature sensor with an associated 2-

byte communication object ("[General] Temperature"), which appears when the the internal

sensor function is enabled in the General parameterization screen. In the box "Internal Temp.

Sensor" it can be configured to send this object periodically ("Temperature sending period") or

after a temperature change ("Sending with a temperature change"), as well as calibrating the

sensor ("Temperature sensor calibration"), in case a deviation between the measurement

taken by the sensor and the room real temperature occurs.

Figure 3.6. Internal Temperature Sensor

Contrast level: the initial contrast level of the display can be set (0-20). This value can be

changed later, if the contrast function of the configuration menu is activated.

In the General section, it is possible to configure a set of specific screens, such as:

Screensaver: to configure the information shown in the display when ZAS is in the

screensaver mode:

 No

 Only time

 Only temperature

 Time + Temperature (shows the current time and temperature, switching between

the two values every 4 seconds).

The time (in seconds) between the last press and the screensaver appearance can be also

configured.