Operation Manual

ZENNiO AVANCE Y TECNOLOGÍA
27
3.4.2. COUPLE BUTTONS
The configuration options for the couple operation of the buttons are the following:
Switch: enables a 1-bit communication object "[Bxy] Binary control" for each couple,
which will be set to value "0" or "1", depending on the button that was pressed. This option
allows introducing the name of the functionality, associated to the buttons, and a text message
for the actions Switch On and Switch Off. The parameter "LED lighting" indicates if the couple
has Regular lighting, with the LED on during some seconds when the button is pressed, or
Status-dependent lighting, where the LED of the button will light while the object status is “1”
and it will remain switched off when the object status is “0”.
Light: 3 communication objects are enabled: "[Bxy] Light On/Off", a 1-bit object to switch
on/off a source of light; "[Bxy] Light dimming", 4-bits object for dimming the luminosity and
"[Bxy] Light indicator", 1-byte object to indicate, in percentage, the luminosity status (0%=Off,
100%=On). The light dimming is carried out as follows:
 Off/Decrease button: a short press switches off the light ("[Bxy] Light On/Off"=0). A
long press decreases the luminosity.
 On/Increase button: a short press switches on the light ("[Bxy] Light On/Off"=1). A
long press increases the luminosity.
This option allows introducing the name of the functionality of these buttons and selecting the
dimming step, in percentage (see table 3.1).
The parameter "LED lighting" indicates if the couple has Regular lighting, with the LED on
during some seconds when the button is pressed, or Status-dependent lighting, where the
LED of the button will light while the object status is “1” and it will remain switched off when
the object status is “0”. The object "[Bxy] Light On/Off" must be linked to the status object of
the light actuator so that the LED is updated.