HT2310 / CHT2310 848D0593A0 (712) G B OWNER’S MANUAL HEDGE TRIMMER HT2310 CHT2310 GB-1
HT2310 / CHT2310 EXPLANATION OF SYMBOLS AND SAFETY WARNINGS HT2310 WARNING!!! RISK OF DAMAGING HEARING Wear head, eye and ear protection. CHT2310 WARNING!!! RISK OF DAMAGING HEARING Wear head, eye and ear protection. MODEL HTZ2310 CHTZ2310 3 22.5 cm 22.5 cm3 SOUND LEVEL ISO 11094 prEN774 LwA(guaranteed) LpAav 108 dB(A) 106 dB(A) 97 dB(A) 95 dB(A) VIBRATION LEVEL ISO 8662 ahv,eq A(8) 2 9.8 m/s 12.
HT2310 / CHT2310 G B EC DECLARATION OF CONFORMITY We, Husqvarna Zenoah Co., Ltd. 1-9, Minamidai, Kawagoe, Saitama, Japan declare in sole responsibility that the following products referred to in this declaration conform with DIRECTIVE 89/336/EEC, 98/37/EC 2000/14/EC Internal control production.
HT2310 / CHT2310 1. Parts location 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Right handle Fuel tank Starter Left handle Throttle lever Ignition switch Throttle Cable Muffler Blade Front handle Rear handle Plate receive 2. Specification Model ............................................................................................. HT2310 / CHT2310 Type ................................................................................................ double-action type HT2310 / CHT2310 .....................
HT2310 / CHT2310 3. Warning labels on the machine (1)Read owner's manual before operat(1) ing this machine. (2)Wear head, eye and ear protection. (3)Handling this machine improperly could result in accidents causing serious injury or death. Read this manual carefully and practice using the hedge-trimmer until you are fully acquainted with all operations and have learned to use it correctly.
HT2310 / CHT2310 5. For safe operation 1. THIS MACHINE CAN CAUSE SERIOUS INJURIES. Read this manual carefully until you completely understand and follow all safety and operating instructions. Also, know how to stop the machine quickly in an emergency. 2. Keep this manual handy so that you may refer to it later whenever any questions arise. Also note, if you have any questions which cannot be answered herein, contact the dealer from whom you purchased the product. 3.
HT2310 / CHT2310 5. For safe operation NOTE Check and follow the local regulations as to sound level and hours of operations for the product. BEFORE STARTING THE ENGINE 1. The area within a perimeter of 15 m of the person using the product should be considered a hazardous area into which no one should enter. If necessary, yellow warning rope, warning signs should be placed around the perimeter of the area.
HT2310 / CHT2310 5. For safe operation • IF SOMEONE COMES 1. Guard against hazardous situations at all times. Warn adults to keep pets and children away from the area. Be careful if you are approached. Injury may result from flying debris. 2. If someone calls out or otherwise interrupts you while working, always be sure to turn off the engine before turning around. MAINTENANCE 1.
HT2310 / CHT2310 6. Fuel ■ FUEL • Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3 m (10 ft) away from the fueling point before starting the engine. agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long.
HT2310 / CHT2310 7. Operation STARTING ENGINE 5. Place the unit on a flat, firm place. Keep the cutting head clear of everything around it. WARNING The cutting head will start moving upon the engine starts. 6. While holding the unit firmly, pull out the starter rope quickly until engine fires. 1. Release the throttle lever and make sure it is fully back. 2. Set the ignition switch to the “RUN” position. b STOP RUN a b STOP RUN 7. After the engine has started, allow the engine to warm up.
HT2310 / CHT2310 7. Operation CUTTING WORK WARNING • Weather conditions and altitude may effect G B carburation. • Do not allow anyone to stay close to the hedgetrimmer while working or while adjusting the carburetor. HOW TO USE : HANDLE (CHT2310) • To reduce fatigue when trimming hedges, the handle can be swivelled through 45° or 90° to the left or right. 45° Horizontal cut: • In order to get the best cutting results, slightly tilt the blade (5÷10°) towards the cutting direction.
HT2310 / CHT2310 8.
HT2310 / CHT2310 8. Maintenance SAFETY LOCK WARNING • Stop operation when the safety lock is defective. WAY OF THE COOLING AIR • This engine is air-cooled. Dust clogging between the inlet port of the cooling air and cylinder fins will cause overheating of the engine. Periodically check and clean the cylinder fins after removing the air cleaner and the cylinder cover. • Safety lock is the device not to accelerate the throttle lever without intention.
HT2310 / CHT2310 8. Maintenance PROCEDURES TO BE PERFORMED AFTER EVERY 100 HOURS OF USE 1. Remove the muffler, insert a screwdriver into the vent, and wipe away any carbon buildup. Wipe away any carbon buildup on the muffler exhaust vent and cylinder exhaust port at the same time. 2. Tighten all screws, bolts, and fittings. 3. Check to see if any oil or grease has worked its way in between the clutch lining and drum, and if it has, wipe it away using oil-free, lead-free gasoline. 9. Storage 1.
HT2310 / CHT2310 11. Troubleshooting guide Case 1. Starting failure CHECK fuel tank fuel filter carburetor adjustment screw sparking (no spark) spark plug → → → → → → PROBABLE CAUSES incorrect fuel fuel filter is clogged out of normal range spark plug is fouled/wet plug gap is incorrect disconnected Case 2.
