NS3526 848A9993A0 (806) G B OWNER’S MANUAL POWER SPRAYER NS3526 GB-1
NS3526 SAFETY PRECAUTIONS Contents Warning labels bearing the mark on the product and in this Manual refer to important safety matters. Please familiarize yourself with them and observe them well. If a warning label on the product becomes soiled or detached, please order a replacement label from your dealer and attach it in the requisite place. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.
NS3526 2.
NS3526 5. For safe operation Before using this product, please read this Operator's Manual thoroughly to ensure correct operation. The following are precautions that should be observed in order to use the product smoothly. Elsewhere in the Manual, warning mark is used to bring your attention to the these precautions. BEFORE USING THE PRODUCT • This product has been designed mainly for the purpose of spraying pest control chemicals and weedkillers.
NS3526 5. For safe operation IMPORTANT Check and follow the local regulations as to sound level and hours of operations for the product. PRECAUTIONS BEFORE SPRAYING • Make sure you have the correct protective clothing, headgear, rubber gloves and boots, a protective mask, goggles, a towel, protective cream, etc., to prevent chemicals from coming into contact with your skin or entering your lungs. When spraying, please wear this protective gear to prevent any risk of injury. 1. 2. 3. 4. 5. 6. 7. 8. 9.
NS3526 5. For safe operation • While spraying please be careful of the wind direction and always stand on the upwind side, to avoid spraying yourself with chemicals. • Should you begin to feel even slightly unwell while spraying, consult a doctor immediately. When doing so, inform the doctor of the name of the chemical you were using, the conditions of use, etc. • If the sprayer is tilted the chemical may leak out through the air holes in the cap.
NS3526 6. Set up ■ Connecting the spray hose and nozzle ■ Adjusting spray pressure • NS3526 has a pressure regulating dial to change spray pressure. Set the pressure at a level appropriate to the spray conditions. a Set the pressure regulating dial as follows: • Turn in a clockwise direction to increase the pressure. • Turn in a counterclockwise direction to decrease the pressure. h f g a. b. c. d. e. f. g. h. spray rod cock grip joint spray hose connecting nut spray outlet rod b b c a c e d 1.
NS3526 7. Fuel ■ FUEL WARNING • Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3 m (10 ft) away from the fueling point before starting the engine. 4. Pour in the rest of gasoline and agitate again for at least one minute.
NS3526 8. Chemical filling WARNING • Chemical substances should be handled correctly, observing the precautions marked on the container. Some chemicals are extremely hazardous to humans and animals, and handling errors can cause serious poisoning or even fatal accidents. • When not in use, chemical substance containers should be stored separately from other containers out of the reach of children. ■ Procedure for filling 1.
NS3526 9. Operation ■ Spraying NOTE • When restarting immediately after stopping the engine, set the choke lever to "open" and the throttle lever to "slow". 3. Place the sprayer in a stable location, and pull the starter knob with the right hand while holding the chemical tank down with the left hand. The starter knob should first be pulled out lightly, then, when resistance is felt, pulled more swiftly and vigorously.
NS3526 10.
NS3526 10. Maintenance • When replacing plugs, please use designated items. NOTE • Warm up the engine before adjusting the idling speed. CHAMPION (RCJ-6Y) IMPORTANT • If too much fuel is absorbed or poor quality oil is used, the spark plug electrodes become dirty, making the engine harder to start. • Note that using any spark plug other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged.
NS3526 10. Maintenance INTAKE AIR COOLING VENT WARNING • Never touch the cylinder, muffler, or spark plugs with your bare hands immediately after stopping the engine. The engine can become very hot when in operation, and doing so could result in severe burns. • When checking the machine to make sure that it is okay before using it, check the area around the muffler and remove any wood chips or leaves which have attached themselves to the brushcutter.
NS3526 13. Troubleshooting guide Case 1. Starting failure CHECK fuel tank fuel filter carburetor adjustment screw sparking (no spark) spark plug Æ Æ Æ Æ Æ Æ PROBABLE CAUSES incorrect fuel fuel filter is clogged out of normal range spark plug is fouled/wet plug gap is incorrect disconnected Case 2.
