User's Manual

Version 1.0 Copyright by Indoorcycling Group GmbH 2009 | www.indoorcycling.com ENG 9
COMMERCIAL INDOOR CYCLING COMPUTER
Before you start
your training: • Make sure the channel setting of the consol is in sync with
the cadence transmitter setting to allow proper cadence reading
• Turn on the computer consol by pressing any of the two buttons
( Sun or Flow)
• Test if the consol reads and displays your HR signal transmitted
from your personal HR chest belt properly
• The blinking of the Heart symbol on the computer display
indicates the reception of a compatible analogue HR signal
• It may takes up to 3 seconds before the actual HR data is
displayed
• Chose your desired units, Miles or Kilometer
How to operate: Miles/kilometer setting:
• Press the “sun” button for 5sec.to enter setup mode. Change
unit setting from Miles to Kilometer by pressing the “flow” button
and confirm your choice by touching the “sun” button again
for 1 sec.
Rest user data:
• Press the “flow” button for 3sec to reset all currently stored
user data such as time, distance and Kcal, average HR and RPM
Engage light function:
• while operating the “sun” button briefly during exercise, the
display illuminates and automatically turns off after 5 sec.
Training info:
• Chose your desired i- training information displayed on the
lower part of the computer LCD by operating the “flow”
button” briefly during exercise. The display will shifted
between time to distance to cal to scan.
• If you chose the Scan mode the display will alternate between
time, distance, kcal
WIRELESS COMPUTER
ENG