User's Manual

Page 12
Magnet:
1. Rotate the right crank until it is at the 2:00 position.
2. Measure out 2.0” from the inside end of the crank and
mark this location.
3. Firmy press the magnet into the groove on the inside
crank arm at the measured location (see picture below).
Checking the Installation:
1. Turn the console on by pressing START.
2. Rotate the cranks for 10 seconds and verify that the
console is picking up the crank rotation and displaying
RPM’s in the cadence section of the display window..
3. If you do not see RPMs in the display window,
press the [CADENCE] key repeatedly until “INST”
RPM is shown in the display window. If RPMs still do
not show, refer to the troubleshooting section of this
manual.
Magnet
2.0”