User`s guide

Ring on Resume

Use the Ring on Resume feature to determine whether the

system automatically wakes up from Suspend mode upon

receiving an incoming modem ring from a serial or PCMCIA

modem.

Low Battery Suspend

Use this feature to automatically enter the suspend mode when

the battery charge is critically low. If you disable this feature,

normal battery low alarms will occur, but the system will not

enter suspend mode unless you push the suspend/resume button.

You can choose Enabled or Disabled.

Note: If you disable this feature and ignore low battery alarms, the system will shut

down when the battery is drained. Also remember, Suspend mode is intended

for short breaks only. For longer breaks, always turn your system completely

off so the battery can recharge.

HDD Timeout Value

Specifies how much time should elapse before the hard drive

automatically shuts off. The next application to access the hard

disk reactivates the motor.

The hard disk timeout interval can be disabled or set to preset

values between 1 minute and 15 minutes.

Remaining Battery Level

Displays the level of usable battery with the horizontal bar when

the battery pack is installed in your system.

Note: If you don’t fully recharge the battery before putting it in, the Remaining Battery

Level may not read accurately.

Chapter 5 - Using SETUP