MSDS

Material Safety Data Sheet
Product Name
Mold & Mildew Stain Remover
Product code
ZUMILDEW
Acute Toxicity
Product/ingredient name Result Species Dose
Exposure
Section 11. Toxicological Information
Sodium Hypochlorite LC50 Inhalation Vapor Rat >10.5 mg/L 0.25 hours
LD50 Dermal Rabbit >10000 mg/kg -
LD50 Oral Rat 8910 mg/kg -
Environmental Effects
N
o known significant effects or critical hazards.
Aquatic Ecotoxicity
Product/ingredient name Test Result Species Exposure
Sodium Hypochlorite - Acute LC50 5.9 mg/L Fish - Minnows 96 hours
Section 12. Ecological Information
Waste Information
Waste Stream
Code: D002
Classification: - [Hazardous waste]
Origin: - [RCRA waste.]
Section 13. Disposal Considerations
Waste must be disposed of in accordance with federal, state and local environmental control regulations. Consult your local or
regional authorities for additional information.
NOTE: DOT classification applies to most package sizes. For specific container size classifications or for size exceptions, refer to
the Bill of Lading with your shipment.
PG* : Packing group
Regulatory information UN number Proper shipping name Classes PG* Label
Hypochlorite solution or
Consumer commodity ORM-D
in limited quantities
8
III
8
CORROSIVE
N
ot determined.
Section 14. Transport Information
DOT Classification
IMDG Class
1791
TDG Classification
U.S. Federal Regulations
Clean Water Act (CWA) 311
: Sodium Hypochlorite (RQ 100 lbs)
Clean Air Act (CAA) 112 regulated toxic substances
: No products were found.
State Regulations
N
o products were found.
California Prop 65
All Components of this product are listed or exempt from listing on TSCA Inventory.
Section 15. Regulatory Information
Clean Water Act (CWA) 307
: No products were found.
N
o products were found.
SARA 313 toxic chemical notification and release reporting:
Canada
WHMIS (Canada)
Class D-2B: Material causing other toxic effects (Toxic).
To the best of our knowledge, the information contained herein is accurate. However, neither the above named supplier nor any of its subsidiaries assumes any
liability whatsoever for the accuracy or completeness of the information contained herein.
F
inal determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution.
A
lthough certain hazards are described herein, we cannot guarantee that these are the only hazards that exist.
*NOTE: Hazard Determination System (HDS) ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or risks
A
lthough these ratings are not required on MSDSs under 29 CFR 1910.1200, the preparer may choose to provide them. HDS ratings are to be used with a fully implemented program to
relay the meanings of this scale.
Section 16. Other Information