Instruction manual

14
6. Assembling the Airdolphin (Z-1000)
j
Fastening the pole to the body (yaw shaft)
1. The wind turbine has six cables. Connect these cables
to the extension cable that passes through the pole.
(See page 20.)
2. Connect the pole to the body (yaw shaft).
Lower the yaw shaft until the end of the pole fastens
inside the yaw shaft.
l
l
Match the seam of the insulator up with the
connection section of the yaw shaft. Affix the
insulator in place.
3. With the body pressed down firmly on
the pole attach the yaw shaft cover
as shown in the figure on the right.
(Tightening torque 22Nm)
Pole
Cables
Body
(Yaw Shaft)
Insulator
Insulator Seam
Yaw Shaft
Attachment Section
Cap Bolt
Long Nut
Hexagonal Wrench
(included)
Yaw Shaft
Cover
Yaw Shaft Cover
Yaw Shaft
1
3
4
2
CAUTION: OBSERVE THE FOLLOWING WHEN ATTACHING THE YAW SHAFT
Tighten the cap bolts (
j
–
m
) in order incrementally so
that all four bolts hold the yaw shaft cover in place with
an uniform degree of tightness.
Tighten the cap bolts leaving no space between the
yaw shaft and the yaw shaft cover
l The yaw shaft and the yaw shaft cover
are designed to be fastened together
tightly around the insulator.
CAUTION: DO NOT CONNECT TO BATTERIES WHEN INSTALLING.
Airdolphin is in brake mode when disconnected from the batteries.
All electrical power
c a ble s sh o u l d r un
inside the tower for
protection.
l
l
Cap bolts shoud be
tightened with the
included hexagonal
wrench with a force of
14 -16Nm
Pole
Yaw Shaft Cover
Yaw Shaft
Insulator
(outer dia mer
is 4 8 . 6 mm)
Almost nil
Almost nil
Match the edge line of the insulator with
the connection section of the yaw shaft.
Affix the insulator in place.