Use, Care and Installation Guide www.zephyronline.com Tempest I , II Stainless Steel Backsplash AK0710 - 30” AK0716 - 36” AK0712 - 42” AK0718 - 48” AK0714 - 54” SEP16.
SPECIFICATION ———————————— 3 INSTALLATION ————————————- 4,5 CLEANING AND CONTACT INFORMATION ———————— 6 1 Table of Contents LIST OF MATERIALS —————————–- 2
Note: If any parts are missing, please call 1-888-880-8368 for replacements.
3 Specifications 30”,36”,42”,48”,54”
Installation 30”,36”,42”,48”,54” 1. Mark a level line on the wall at 16” below bottom of hood. 2. Position the lower section of backsplash (flat part with flange on top) on the wall. Center it side to side and mark the top and bottom holes. Remove the lower section from the wall. 3. If installing onto drywall only and not onto studs, insert wall anchors (we recommend EZ anchors) into the marked holes. If installing onto studs, attach screws without EZ anchors. 4.
Installation 30”,36”,42”,48”,54” 1. For the warming plate option; snap the wire shelves into hinge clips on the backsplash as shown in the left side shelf diagram. 2. For the spice rack option; attach shelf to hinge clips, as show in the right side shelf diagram, then rotate shelf upwards and secure with retaining clip.
When cleaning, use a non abrasive cleaner, do not use “orange” cleaner. Abrasive cleaners may scratch the surface and discolor the stainless steel. To clean the wire racks, soak them in soapy water. DO NOT place in a dishwasher as this may discolor the wire racks. You may also polish the stainless steel by using stainless steel polish. Make sure when polishing to go along with the grain of the backsplash.