Installation Guide

Installation – Mounting the Range Hood
13
Hood is designed for installation under a kitchen
cabinet (Fig 1)
1. Selectpreferredductlocation(verticalorhorizontal)if
ductingoutofkitchen.Refertopage7fordetails.
2. Begininstallationbyremovingthelters(ifinstalled)
andsidespacerpanels(36”modelsonly).(Fig2)
3. Reinforcecabinetwith1”x2”woodstripsifadditional
strengthening is required or if cabinets are framed.
4. Temporarily position the range hood in the desired
mountinglocation.Measureandmarkthemounting
holes, duct and electrical locations with a pencil.
5. Drill/cutouttherequiredopeningsforductand
electrical access by following the dimensions on page
8;makesuretheductopeningislargeenoughtoapply
duct tape.
6. Fastenhoodontocabinetwith(4)M4woodscrews
with washers provided.
7. Install electrical.
8. Installductworkandsealwithducttape.
9. Reinstallltersandsidespacerpanels(ifapplicable).
10.Poweruphoodandcheckforleaksaroundducttape.
11. If recirculating the hood refer to page 11 and 12 for
details.
duct/silver
tape
Duct
opening
cutout
Add 1x2
wood strips
electrical
Fig 1
(Shownasverticalducting)
Push in on panel latch then pull panel down
Fig 2