Installation Guide

16
www.zephyronline.com
BREEZE I, AK11xx
REPLACING LIGHT BULBS
CAUTION: Light bulb becomes extremely hot when turned on.
DO NOT touch bulb until switched o󰀨 and cooled. Touching hot bulbs could cause serious burns.
Makesureallpoweristurnedo󰀨andbulbsarenothot.
Removebyturningbulbcounterclockwise.Note: Bulb does not unscrew; it turns 60 degrees, stops and falls out.
Ifbulbsaredi󰀩culttoturnduetoprolongeduse,rmlyattachaglasssuctioncupapproximatelythediameterofthe
bulborusearubber/latexgloveandturncounterclockwise.
Replacement bulbs are available at most hardware stores or from www.zephyronline.com
PurchasetypeMR16(GU-10)35Whalogen.
Maintenance – Lights
BREEZE II, AK12xxBx
LED LIGHT STRIPS
IntheunlikelyeventthatyourLEDstripfails,pleasecontactZephyrtoorderreplacementparts.
See list of parts and accessories page for part #’s and contact information.
To replace LED light strip
1.Removealuminummeshlters.
2. Remove light panel by two screws.
3.DisconnectLEDlightstripquickconnector.
4. Push in the two side clips on the ends of the LED strip.
5. Push LED light strip through the light panel opening.
Push the clip
Breeze I, AK11xx
Breeze II, AK12xxBx