Owner's Manual
26
Tempest I Use, Care, and Installation Guide
TEMPEST I
UNDERCABINET
PRO
Features & Controls
Touch Controls
Charcoal Filter Change Reminder (charcoal filter, if installed)
When your hood is installed as a recirculating unit, it is fitted with a set of charcoal
filters to purify exhaust and fumes from cooking, then re-circulates the air within the
home. These charcoal filters are required to be replaced after every 200 hours of use.
The charcoal filters should never be cleaned or placed in a dish washer.
The filter change reminder function in the microprocessor needs to be switched on.
When switched on, the microprocessor will elapse and count usage time and indicate
by a flashing when charcoal filter replacements are needed.
Setting the Filter Change Reminder
When o, hold for approximately 5
seconds. The display will change from
(exhaust mode) to (recirculating mode)
this indicates that the elapse timer function
is switched on and charcoal filters are used.
Filter Replace Indicator
When the display starts flashing, the
charcoal filters need to be replaced.
Re-setting Function
Once filters are replaced, with hood o,
press and hold the display will appear;
hold for apprimately 5 seconds until
on displays disappears . The filter
change reminder is now re-set and a new
200 hour elapse cycle is initiated.
hold 5 sec. display from < - > to < C >
Set Mode
Set Mode
display < C > flashes
Change Filters
hold 5 sec. display from < C > to < >
To Reset
C
C
C
C
C
C
C