User Manual

15
Titan Island Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Installation Instructions
3. Attach square support bracket inside the support frame assembly. The placement of the square
support bracket should preferably be aligned in the middle where the top and bottom frame
intersect (FIG. E1). Install (8) M4 x 8 screws to secure the square support bracket onto the frame.
Mount diagonal support brackets onto the support frame assembly facing away from each other
in a crossed formation (FIG. E2). The diagonal support brackets have a ledge on the side. During
installation, mount the diagonal support brackets with the ledge facing inwards to the unit (FIG.
E3). Install (4) M4 x 8 screws to secure the diagonal support brackets onto the frame.
4. Lift support frame assembly up to the ceiling making sure the word “front” on the top support
frame faces the front of the hood where the controls will be located (FIG. D). The key holes on the
top support frame should cover the wood screws previously installed in the ceiling. Slide support
frame towards narrow end of key holes to lock the frame in place. Install the last (4) M6 x 2” wood
screws with washers into the four remaining holes of the top support frame to secure it to the
ceiling. (2) M6 x 2” wood screws with washers are installed on the corners and the other (2) M6
x 2” wood screws are installed on the front and rear long sides of the support bracket (FIG. D).
Tighten all screws.
Mounting the Hood
FIG. E
1.
2.
1/2
bottomtop
3.
3.