Owner's Manual

Monsoon II Use, Care, and Installation Guide

MONSOON II

INSERT

PRO

ACT™ Conversion

Enabling ACT™

To enable ACT™:

1. Before hood installation, gain access to PC board by following the steps shown on FIG. I.

2. Change plastic jumper positioning as shown in FIG. J to set the desired maximum blower CFM.

3. Re-install PC board and continue with hood installation.

4. Remove the appropriate foil CFM sticker included with the hood literature and place inside the

hood body below the wiring diagram or in another clearly visible location.

To verify if your installer enabled ACT™:

1. With hood o, press and hold the power button for three seconds. If the number 6 displays =

defualt max. CFM, if the number 3 displays = max. 590 CFM, and if the number 2 displays = max.

390 CFM.

2. When ACT™ is enabled, the number of blower speeds will be reduced.

590 CFM = max. 3 speeds and 390 CFM = max. 2 speeds.

3. There should also be a foil label located inside the hood body near the wiring diagram that

indicates the blower CFM.