manual

- 20 -
FRAMING BEHIND WOOD
CROSS SUPPORT
WOOD CROSS
SUPPORT BEHIND
DRYWALL
DRYWALL
16-1/2”
17-5/8” FROM
BOTTOM OF HOOD
HOOD
BOTTOM
INSTALL THE HOOD
Remove the plastic protective film from all
exterior surfaces, decorative flues and filters,
prior to final installation
1. Construct wood wall framing that is flush with
interior surface of wall studs (Fig.17/18).
Make sure:
a) the framing is centered over installation
location.
b) the height of the framing will allow the hood to
be secured to the framing within the
dimensions shown.
2. Determine desired height over cook top
and mark hood bottom line. Install screws
per dimensions shown in Fig. 17/18.
3. Hang the hood onto the screws.
4. Tighten mounting screws. Add additional
screws through hood body as needed for
additional support.
Notes:
a. Minimum hood distance above cook top
must not be less than 22”. A maximum of
32” above cook top is highly
recommended for best capture of cooking
impurities. Distances over 32” are at the
installer and the users discretion; and if
ceiling height and flue lenght permit.
FIG.17
FRAMING BEHIND WOOD
CROSS SUPPORT
WOOD CROSS
SUPPORT BEHIND
DRYWALL
DRYWALL
FIG.18
Model Incline
Model Wave
18-7/8”
13-3/8” FROM
BOTTOM OF HOOD
HOOD
BOTTOM