Troubleshooting guide

COMPUTER OPERATION

BUTTON FUNCTIONS

MODE THE “MODE” BUTTON WILL SELECT AND SCROLL THROUGH EACH DISPLAY

FUNCTION.

RESET THE RESET BUTTON CAN BE USED TO ZERO OUT AN INDIVIDUAL DISPLAY

FUNCTION.

TOTAL RESET THIS BUTTON WILL ZERO OUT ALL DISPLAY READINGS AND PRESET VALUES.

NOTE: THE REMOVAL OF THE BATTERIES WILL ALSO RESET ALL DISPLAY

FUNCTIONS TO ZERO.

UP THIS BUTTON ADJUST (INCREASES) FUNCTION VALUES.

DOWN THIS BUTTON ADJUST (DECREASES) FUNCTION VALUES

DISPLAY FUNCTIONS

SPEED THE COMPUTER WILL REFERENCE A TRAINING SPEED BASED ON

CORRESPONDING PEDAL RPM.

TIME COMPUTER DISPLAY WILL ACCUMULATE TOTAL TRAINING TIME IN 00:00

(MINUTES : SECONDS). COMPUTER WILL COUNT UP TO A MAXIMUM

DISPLAY READING OF 99:99.

PRESET TARGET TRAINING TIME: USE THE “MODE” BUTTON TO SCROLL

TO TIME FUNCTION AND PRESS THE “UP OR DOWN” BUTTONS TO SET THE

DESIRED TIME. SETTINGS WILL BE ENTERED IN 1:00 MINUTE INCREMENTS

AND THE COMPUTER WILL COUNT DOWN FROM THE SET TIME. ONCE THE

DESIRED TIME IS SET, START PEDALING TO BEGIN TRAINING OR PRESS THE

“MODE” BUTTON TO CONTINUE THE TARGET SET UP OF OTHER FUNCTIONS.

DISTANCE THE COMPUTER ACCUMULATES TRAINING DISTANCE FROM 0.00 TO A

MAXIMUM OF 99.99 MILES. EACH INCREMENT WILL BE DISPLAYED IN 0.01

MILE.

PRESET A TARGET TRAINING DISTANCE: USE THE “MODE” BUTTON TO

SCROLL TO THE TIME FUNCTION AND PRESS THE “UP OR DOWN” BUTTON

TO SET A DESIRED DISTANCE. EACH SETTING WILL BE IN INCREMENTS OF

0.5 MILE AND THE COMPUTER WILL COUNT DOWN FROM THE SET

DISTANCE. ONCE THE DESIRED DISTANCE IS SET, START PEDALING OR

PRESS THE “MODE” BUTTON TO CONTINUE THE TARGET SET UP OF OTHER

FUNCTIONS.

SCAN THE COMPUTER WILL AUTOMATICALLY SCAN (CYCLE) THROUGH EACH

FUNCTION READING EVERY 5 SECONDS. THE LARGE CHARACTER

INFORMATION WILL CORRESPOND TO A BLINKING FUNCTION WINDOW AT

THE BOTTOM OF THE DISPLAY. SCAN (CYCLING) SEQUENCE; SPEED, TIME,

DISTANCE, AND CALORIES.

NOTE: THE SCAN FUNCTION CAN BE TURNED OFF DURING A TRAINING

SESSION BY PRESSING THE “MODE” BUTTON ONCE. THE SCAN SEQUENCE

CAN BE REACTIVATED BY USING THE “MODE” BUTTON TO MANUALLY

SCROLL TO THE BEGINNING FUNCTION WINDOW (SPEED READING).

AT THIS

POINT, THE WORD “SCAN” WILL APPEAR IN THE UPPER LEFT CORNER AND

AUTOMATICALLY BE REACTIVATED.

PAGE 9