Troubleshooting guide

ASSEMBLY STAGE #2
Attach Console Mast & Mount Computer on the Main Base
Assembly Hardware Required:
#25 Carriage Bolt Qty. 2 #33 Spring Washer Qty. 2
#26 Pan Head Screw Qty. 2 #34 Acorn Nut M6 Qty. 2
Assembly Description:
A) Carefully route the Sensor Cable (#4) through the Computer Mast (#6) and slide the mast down onto the
corresponding mounting area of the Base Frame Assembly. Secure the mast to the base frame using 2-Carrriage
Bolts (#25), 2-Spring Washers (#33), and 2-Acorn Nuts (#34).
B) Install (2) AA Batteries into the back of the Computer (#5), as shown in Figure 2. Connect the Sensor Cable (#4)
to the receptacle end of the cable coming from the back of the computer. Tuck the excess cable length into the mast
and slide the computer onto the mast mounting plate. Secure the computer in place using 2-Pan Head Screws (#26).
 Assembly Stage #2 completed.
A
SSEMBLY INSTRUCTION PAGE 5
34
25
33
4
6
5
Figure 2
#4 Sensor Wire
Computer Back View
26