Installation guide

(blower

housing)

Ductless recirculation is intended for applications where an exhaust duct work is not possible to be installed.

When converted, the hood functions as a recirculating hood rather than an exhaust hood. Fumes and exhaust

from cooking are drawn and filtered by a set of optional charcoal filters. The air is then purified and re-

circulated back within the home.

We recommend to ALWAYS exhaust air outside of the home by employing existing or installing new duct

work, if possible. The hood is most effective and efficient as an exhaust hood. Only when the exhaust option

is not possible should you recourse to converting the hood into a recirculating hood.

When converted to be a recirculating hood, a set of charcoal filters are required on top of its standard Metal

Filter set. Order according to its part number below. The standard metal filters are intended to capture

residue from cooking and the optional charcoal filters help to purify fumes exhausted from cooking for re-

circulation.

RECIRCULATING KIT (REQUIRED IF NO DUCTING IS USED)

Kit includes charcoal filters and air diverter plate.

Hood Model Part No. Filters in Pkg.

BMI & BSI models BRC-0002 2

BVE models BRC-0001 2

1. Purchase recirculating kit per the part number above

2. Secure air diverter plate to wall below duct cover bracket. (FIG. B)

Run 6” ducting from top of hood and secure to air diverter plate. See

manual included with recirculating kit for more detailed instructions.

3. Remove metal mesh filters from hood. Secure the charcoal filter

bracket onto the inside of the hood behind mesh filters with (4) M3.5 x 8

screws. Clip charcoal filters onto each charcoal filter bracket. (FIG. C)

4. Re-Install metal mesh filters.

5. Charcoal filters must be replaced after every 120 hours of use (or approximately every 3 to 4 months

based on the average of 1 - 2 hrs. of daily cooking time).

Charcoal Filter Replacements

Hood Model Part No. Qty to Order

All Brisas Models Z0F-C002 2

DO NOT WASH CHARCOAL FILTERS. Charcoal filters may need

to be changed more often depending on cooking habits.

Charcoal Filter Dimensions:

9in x 6-3/8in

228mm x 162mm

Installation – Ductless Recirculating

Install charcoal filter (plastic side exposed)

into charcoal filter bracket. Insert tab

cut-out side D of charcoal filter into bracket

first. Lock charcoal filter into place by

pushing down on side E with locking tabs.

front of the hood

back of the hood

FIG. C

FIG. B