Installation guide

7. Place blower over round to rectangular adapter

as shown above.

8. Install blower with round to rectangular adapter

into hood.

Installation – Internal Blower (Horizontal Ducting)

9. Mount blower brackets to hood using two

3/16” * 3/8” screws for each bracket. Screws

are included with internal blower.

10. Install rectangular starting collar to back of hood

using six M4*8 screws recently removed from

rectangular cap (three screws on each side).

Install four additional M4*8 screws in the top

and bottom middle of rectangular starting

collar. Check and verify inner adapter is ﬁ rmly

secured.

11. Connect 9 pin male connector from blower to 9

pin female connector on control board box.