Owner's Manual

www.zephyronline.com

1. Determine the location for mounting the hood. Mark centerlines front to back and left to right of hood placement.

Place supplied paper template on ceiling and center marked center lines with template center lines. Mark

mounting holes for ceiling bracket and telescopic rod couplers.

2. Cut out hole in ceiling for the duct work and electrical wiring passage.

3. Add and secure wook blockings (minimum 2x4 studs) between ceiling joists for celing bracket and telescopic rod

couplers if needed. FIG. 1.

4. Center, mark and fasten ceiling bracket onto ceiling using (4) M4*38 screws. Make sure the word “FRONT”

displayed on the ceiling bracket is facing the front of the hood where the controls will be located. FIG. 2.

5. Attach telescopic rod couplers to marked locations on ceiling using (1) M4*2” wood screw for each coupler. Make

sure the set screw mounting hole is toward the bottom of the coupler during mounting. FIG. 2.

6. Prepair and position electrical wiring and duct work through ceiling bracket.

ELECTRICAL WARNING

All Electrical work must by performed by qualiﬁ ed electrician or person with similar technical know how and background.

For personal safety, remove house fuse or open circuit breaker before beginning installation. Do not use extension cord or adapter

plug with this appliance.

Follow national electrical codes or prevailing local codes and ordinances.

Electrical Supply: This appliance requires a 120V 60Hz electrical supply, and connected to an individual, properly grounded

branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire w/ ground. Please also refer

Electrical Diagram labeled on product.

Cable Lock: A cable locking connector (not supplied) might also be required by local codes. Check with local requirements and

codes, purchase and install appropriate connector if necessary.

Installation – Mounting the Range Hood

Add Blockings

Tabs

Ceiling Bracket

Mounting

Holes

Marking for Coupler

Electrical wiring

passage

Ceiling

Set screw mounting

hole

FRONT

FIG. 1

FIG. 2