Manualshelf

Hood User Manual

ManualsBrandsZephyr ManualsCooking Appliances36 Inch Milano Wall Mount Smart Range Hood with 700 CFM PowerWave Blower with Airflow Control, Proximity Controls, Tri-Level LED Lighting, Mesh Filter, CleanAir Function, Zephyr Connect, and ADA Compliant: Stainless Steel Canopy
11121314151617181920
14
Milano Use, Care, and Installation Guide
MILANO
WALL
CORE
Installation Instructions
Mounting the Hood
At least two installers are required due to the
weight and size of the hood.
CAUTION
1. Measure from range top to hood bottom and
mark line A. (24” minimum from range top).
2. Plum and mark center line.
3. Mark mounting height line B. (18-5/8” from line
A).
4. Mark mounting spread from C/L. (11-1/4”).
5. Fasten (2) #6 x 1-1/2” screws into studs on line B
but do not tighten all the way.
Wood blocking may need to be added behind
the drywall if no studs are present. Wall anchors
may also be used but check local codes for
compliance. Failure to use suitable wall anchors
and screws to hold the weight of the hood could
result in personal injury or damage to cooking
surface or counter.
WARNING
FIG. B
Brackets are
pre-installed
2
24” min.
1
11-1/4”
C/L
C/L
B
A
18-5/8”
Duct Cover
Bracket
6. Remove tape and (2) screws securing electronics mounting bracket to hood. Reposition electronics
mounting bracket as shown in (FIG. A3) and secure to motor housing using the (2) previously
removed screws.
7. Remove (2) screws securing electrical junction box to electronics mounting plate. Remove junction
box. (FIG. A1).
8. Remove the (1) aluminum mesh filter.