User Manual

1. Measure from range top to hood bottom and mark line A.

´PLQLPXPIURPUDQJHWRS

2. Plum and mark center line.

 0DUNPRXQWLQJKHLJKWOLQH%´IURPOLQH$

4. Mark mounting spread from C/L on line B. From C/L to left

PRXQWPDUN´)URP&/WRULJKWPRXQWPDUN´

 )DVWHQ[´VFUHZVLQWRVWXGVRQOLQH%'RQRW

fasten screws all the way. Note: wood blocking may need

to be added behind the drywall if no studs are present.

Wall anchors may also be used but check local codes

for compliance. Failure to use suitable wall anchors

and screws to hold the weight of the hood could result

in personal injury or damage to cooking surface or

counter.

 +DQJKRRGRQWRVFUHZVDQGKDQGWLJKWHQ),*$8VH

WKHODVW[´VFUHZVWRIXUWKHUVHFXUHWKHKRRGWRWKH

wall from inside the hood.

7. Center and attach duct cover bracket to wall below ceiling or

VRI¿WXVLQJ[´VFUHZV

8. Install electrical.

,QVWDOOGXFWZRUNDQGVHDODOOMRLQWVZLWKFHUWL¿HGGXFWWDSH

10. Power up hood and check for leaks around duct tape.

11. Place telescopic duct covers onto hood and extend inner

WRSGXFWFRYHUXSZDUGVDQGVHFXUHWRGXFWFRYHUEUDFNHW

XVLQJ0[VFUHZV

*If using hood in recirculating mode you must secure air

diverter plate onto wall before installing duct work and duct

covers. Turn to page10 for more details.

C/L

12 1/4"

C/L

26" min

fig. A

Duct Cover Bracket

2"3-1/2"

CAUTION: At least two installers are

required due to the weight and size of the

hood.

WARNING: Electrical wiring must be done by a qualified person(s) in

accordance with all applicable codes and standards. This range hood must be

properly grounded. Turn off electrical power at service entrance before wiring.

Installation – Mounting the Hood

FIG. A