Instruction manual

Run Mode Jester Operating Manual
Jester Manual 73-403-00 Issue 3.4 23 of 53
Selecting the Next Memory
The LCD and monitor display data about the current and next memories. The cursor
up or down buttons are used to select the next memory to be output.
Pressing the cursor down button will take you to the next programmed memory.
When the last programmed memory is reached, pressing the cursor down button
will take you to the first programmed memory.
Pressing the cursor up button will take you to the previous programmed memory.
When the first programmed memory is reached, pressing the cursor up button will
take you to the last programmed memory.
Pressing cursor up and cursor down together will select the first programmed
memory.
To Determine the Current Memory
The LCD display shows the current memory number in the left hand side of the
display – <C: #>. This is also shown in the monitor, highlighted with a green bar.
Outputting a Programmed Memory
The cursor up or down buttons are used to select the next memory to be output. The
PROGRAM/GO button is used in run mode as the GO button, which will initiate a
dipless crossfade between the current memory and the next memory. The LCD
automatically selects the next programmed memory, and changes the current (C:)
memory to the one which is now being output. The crossfade takes its time from the
programmed ‘Fade’ time for the incoming cue. This crossfade time can be manually
overridden by moving the FADE TIME pot to an appropriate value.
Pausing a Crossfade
1. Use the cursor buttons to select the next memory to be output.
2. Press the PROGRAM/GO button. This initiates a crossfade to the selected
memory, in the time defined by the memory. While the crossfade is taking place,
the red FADING light flashes.
3. To pause the crossfade, press and hold the SHIFT button and press the
PROGRAM/GO button. The PROGRAM/GO light and the red FADING light will
flash and the outputs remain static.
4. To restart the crossfade, press the PROGRAM/GO button again. The crossfade
continues. When the crossfade is complete, the red FADING light goes out. The
PROGRAM/GO button will stop flashing as soon as it is pressed.
NOTES
Selecting Memories
Only programmed memories are selectable. Any unprogrammed memories are
ignored.