Instruction manual

Jester Operating Manual Glossary
48 of 53 Jester Manual 73-403-00 Issue 3.4
Sound2Lite
The ability to control lights in time to a beat. The Jester has a sound2lite input which
listens to the input music and, according to the settings of the chase, changes the
lights in time to the beat.
Speed Pot
The control for setting the speed of chases on the Jester. This is located on the right
hand side of the front panel.
Store
The function of the PROGRAM/GO button when the desk is in Wide preset mode.
The button is coloured YELLOW and toggles between A FADERS B STORED and B
FADERS A STORED.
Super User
The area of the Jester where settings can be altered. This is accessed via
SHIFT+MODE.
Terminator
A 120Ω ½ Watt resistor soldered between pins 2+3 of a male XLR, which provides
protection against signal ‘bounce’. This should be placed at the end of a DMX signal
chain.
Time
The JesterJester allows you to define fade up and fade down times for a memory,
which define how quickly the memory will run.
Topset
The ability to set a ‘top’ level for a channel. This is generally set on the dimmer itself.
The Jester does not allow you to set a top level for a channel.
USB
Universal Serial Bus. A standard for the transfer and storage of information. The
Jester has a USB port mounted on the front panel to allow storage of show files.
VGA
Video Graphics Array. The monitor output on the back of the Jester is VGA – see
Displays Setup in Super User for further details.
Wide
Wide mode is when the Jester enables all of its faders for use as channel faders. In
this mode, Preset B becomes control of the second half of the channels.
www.zero88.com
The address of the Zero 88 website.