Instruction manual

Setup Mode JesterML Operating Manual
73-406-00 Issue 3.0 51 of 85
 RDM – this automatically creates fixture profiles by loading the information
directly from the fixture itself using RDM.
Loading from the Fixture Library
 Select the first letter of the manufacturer name using the Multi-Function-Keys.
 Select the manufacturer using the Multi-Function-Keys. If there are more than
10 manufacturers in the group, then use the Page Up and Page Down buttons
to select the appropriate page.
 Select the fixture type using the Multi-Function-Keys. If there are more than 10
fixture types for that manufacturer, then use the Page Up and Page Down
buttons to select the appropriate page. For fixtures with multiple modes, it is
very important to ensure that the mode selected on the fixture matches that of
the fixture profile.
 Select the location(s) to assign to using the Multi-Function-Keys. Multiple
locations can be selected if required, which is a quick way of assigning several
fixtures of the same type together.
 Select <Assign> and press ENTER. The name of the fixture will now appear
on the LCD above the corresponding Multi-Function-Key.
Loading from a User File or USB
 Select the file using the left and right cursor keys, and then press ENTER.
 Continue with the selection process as described in 0 above.
Loading from RDM
 Wait for the desk to find the first device, this normally takes around 5s. The
manufacturer and type will then be displayed.
 Select <Identify> and press ENTER to see which device has been found. The
exact response of the device is dependant on the device manufacturers
implementation of this RDM function. Press ENTER again to cancel the
identify.
 If the device has more than one personality or mode, then the name of the
current personality will be displayed. This can be changed if required by
selecting the personality name, then using the left and right cursor keys.
 If the device is a fixture, select the location to assign to using the Multi-
Function-Keys. Multiple fixtures of the same type can be assigned to a single
location, which will allow duplicate DMX patches to be created later.
 If the device is a dimmer, enter the channel number to assign to.
 Select <Assign> and press ENTER. For fixtures, the parameter information will
then be loaded from the device (the desk skips this stage if it has previously
loaded another fixture of the same type). The desk will create a Virtual
Intensity channel if necessary.