User's Manual

TCP IP Status:

1. Click Setup, it then appears the sub-menu.

2. Click TCP/IP, it then as shown in the following picture.

DHCP/BOOTP: This option allows you to select DHCP/ BOOTP option. If there is a

DHCP/BOOTP server on your network. This option allows the print server

to obtain IP-related settings automatically from your DHCP server.

IP Address: This option allows you to input IP address from the print server. The IP address

must meet the IP addressing requirements of the network segment.

Subnet Mask: This option allows you to input subnet mask from the print server. The IP

address must meet the IP addressing requirements of the network segment.

Gateway: This option allows you to input gateway from the print server. This IP address of

gateway must meet the router or gateway to go across of the network segment.

NetWare Setup

1.Log into your NetWare file server as a Supervisor (Admin.) or equivalent.

2.Select NetWare and type in the Print server that created during PCONSOLE Select the

NetWare File Server to which the print server device will be attached.

3.Click Setup, it then appears the sub-menu.

4.Click NetWare, it then as shown in the following picture.