Instruction manual

Memories
Page 100 Solution & Solution XL Operating Manual – Issue 1.0
Editing a Chase Step
Press the MEMORIES key to display the Memories Window. Select the
memory to be edited, then press the LOAD key. The Load Window is
displayed on the monitor:
Figure 81 - Load Memory (Chase)
Select the required memory number and step number, if different to the
default numbers displayed. Select the [OK] button to load the chase step into
the programmer.
Adjust the levels of the dimmer channels as required using the preset faders.
Adjust the levels of the fixture parameters as required using the MFKs and
control wheels.
Press the UPDATE key. The Update Options Window is displayed on the
monitor. Set the update options as required and then select the [OK] button to
complete the edit.
Adding a Chase Step
Press the MEMORIES key to display the Memories Window on the monitor.
Select the chase memory to be edited. Move the cursor to the Step field. Use
the +/- keys to select the step before the point at which you wish to insert a
new step (eg to insert a step after step 4, select step 4).
Press the INSERT key. A new unprogrammed step is added into the chase
after the selected step.
Set the levels of the dimmer channels using the preset faders. Set the levels
of the fixture parameters using the MFKs and control wheels.
Press the RECORD key to record the data into the new step of the chase. Any
original steps in the chase after the inserted step are renumbered accordingly.
Deleting a Chase Step
Press the MEMORIES key to display the Memories Window on the monitor.
Select the chase memory to be edited. Move the cursor to the Step field. Use
the +/- keys to select the step to be deleted.
Press the DELETE key. A confirmation window is displayed. Confirm the
step deletion.
Any original steps in the chase after the deleted step are renumbered
accordingly.