Instruction manual

Memories
Solution & Solution XL Operating Manual – Issue 1.0 Page 105
Alternatively, the Next memory may also be selected by moving the cursor to
the No field, pressing the ENTER key, entering the required memory number
and pressing ENTER.
Starting the Show
Set the Playback X MASTER and GRAND MASTER faders to full. Ensure that
Blackout is not active. Set the OVERRIDE control to it‟s central position.
Select the first programmed memory and press the GO key. The memory
fades up on the outputs according to it‟s programmed fade and delay times.
Using the GO Key
The GO key initiates a transition from the Current memory to the Next
memory, as indicated on the Memories Window.
When the GO key is pressed the Current and Next memory numbers are
incremented automatically. The Current memory number becomes what was
the Next memory number; the Next memory number becomes the next
programmed memory in the stack.
When a memory is triggered by the GO key, the Intensity, Colour, Beamshape
and Position fades start immediately (assuming that the corresponding Delay
times are zero).
If an attribute delay time is non-zero, then the fade starts after the defined
delay time.
The Dimmers and Fixture Intensity, Colour, Beamshape and Position
parameters programmed in the memory fade to their programmed values
according to the corresponding fade times for the memory.
While the outputs are fading to the programmed values in the memory the
LEDs in the GO key flash. When all programmed channels have reached
their programmed levels, the LEDs in the GO key stop flashing and remain on.
All fades may be controlled by the OVERRIDE and PAUSE controls on the
front panel (see later in this section).
Notes – GO Key Operation
Holding down the SHIFT key and pressing GO snaps to the Next cue in
the cue stack (ie all delay and fade time information is ignored).
If you select an unprogrammed memory as the Next memory on the
Memories screen and then press the GO key, an error message is
displayed. When this error message is cleared, by pressing the ENTER
key, the Next memory field automatically displays the next highest
programmed memory in the memory stack.
The GO key on the front panel does not auto repeat.
After a GO on the last programmed memory in the stack, the Next
memory automatically becomes the first programmed memory in the
stack.
Override Control
The OVERRIDE control slows down or speeds up time, allowing manual
adjustment of a crossfade as it happens.
Turn the OVERRIDE control anti-clockwise to slow down the crossfade
between memories or clockwise to speed up the crossfade.
Playback X Master Fader
The playback X MASTER fader controls the maximum output levels of the
dimmers and fixture brightness channels only. The fixture colour, beamshape
and position channels are not affected by the Playback X MASTER fader.