Instruction manual

Submasters
Page 110 Solution & Solution XL Operating Manual – Issue 1.0
When the submaster is raised - At the Trigger Level, the Beamshape
parameters will crossfade to their programmed values in the
programmed time. As the fader travels upwards, the programmed
position and colour channels will crossfade to their programmed values,
relative to the level of the fader (eg at 50%, the position and colour
channels will be 50% of the way between their old values and the ones
programmed into the submaster).
When the submaster is lowered - As the fader travels downwards, the
programmed position and colour channels will crossfade from their
programmed value, relative to the level of the fader (eg at 50%, the
position and colour channels are half way between the value on the sub
and the one which the value previously came from).
When the submaster reaches 0%, the non-fader controlled channels (in
this case, Beamshape), will be released and return to their previous
source or default value if no other source exists.
Triggering Macros from Submasters
This option in the Submaster Setup Window allows you to specify a user
defined macro to be triggered when the submaster fader is raised.
Select the [Macros …] option in the Submaster Setup Window. A Submaster
Macro popup window is displayed:
Figure 90 - Submaster Macros
Select the [User Defined Macro] field in the window. Enter the required macro
number and then press ENTER to complete. Only valid programmed macro
numbers are allowed.
When a macro has been associated with a submaster this is indicated in the
Comments field on the Submasters Window, eg M:23.
Chase Modifiers
Example Submaster Setup Window for a chase:
Figure 91 - Submaster Chase Modifiers