Instruction manual

Submasters
Solution & Solution XL Operating Manual – Issue 1.0 Page 119
 The fixture Colour, Beamshape and Position channels are automatically
triggered and snap to their programmed levels (providing the submaster
fader is below the LTP trigger level).
On release of the SUBMASTER FLASH button:
 The dimmers and fixture brightness channels programmed in thsubmaster
return to zero (or the level corresponding to the submaster fader level if
the fader is avove zero). All other dimmers and fixture brightness
channels that were reduced to zero return to their previous output values.
 The Colour, Beamshape and Position channels are released.
Latch
Press the required SUBMASTER FLASH button. The LED in the
SUBMASTER FLASH button comes on and the outputs are as follows:
 The programmed dimmers in the scene, chase or transferred memory
data on the submaster snap to their programmed levels.
 The fixture Brightness channels snap to their programmed levels.
 The Colour, Beamshape and Position channels are triggered
automatically and snap to their programmed levels.
Press the required SUBMASTER FLASH button again. The LED in the
SUBMASTER FLASH button goes out and the outputs are as follows:
 The dimmers and fixture brightness channels return to zero (or the level
corresponding to the submaster fader level if the fader is avove zero).
 The Colour, Beamshape and Position channels are released.
Go
Press the required SUBMASTER FLASH button. The LED in the
SUBMASTER FLASH button comes on and the outputs are as follows:
 The programmed dimmers and fixture brightness parameters in the
scene, chase or transferred memory data on the submaster fade up to
their programmed values in the submaster Fade Up time.
 The Colour, Beamshape and Position channels are triggered
automatically when the internal submaster fader reaches the LTP trigger
level and then fade to their programmed levels in their respective fade
times.
Press the required SUBMASTER FLASH button again. The LED in the
SUBMASTER FLASH button goes out and the outputs are as follows:
 The dimmers and fixture brightness channels fade down to zero (or the
level corresponding to the submaster fader level if the fader is above
zero).
 The Colour, Beamshape and Position channels are released.
Off
Pressing the SUBMASTER FLASH button simply selects the submaster
where applicable. The outputs are not affected.