Instruction manual

Macros
Page 136 Solution & Solution XL Operating Manual – Issue 1.0
Running a Macro
A macro can be run using any of the following methods:
 Click on the macro in the Macro Window on the monitor.
 Use the cursor keys to select the macro in the Macro Window and then
press the ENTER key.
 Press the MACRO key to make the MFKs macro selection keys. Use the
PAGE UP or PAGE DOWN keys to select the required page. Press the
macro MFK.
 Triggering a memory with an associated macro.
 Raising a submaster with an associated macro.
Note – Running Fixture Macros
To run one of the automatic fixture macros (Reset, Lamp On or Lamp
Off) select the fixture(s) first before running the macro as described
above.
Deleting a Macro
Display the Macro window on the monitor. Select a programmed macro to be
deleted.
Press the DELETE key. The Delete Window is displayed on the monitor:
Figure 122 - Deleting a Macro
Select the [OK] button. A confirmation window is displayed. You can then
confirm the deletion or cancel the operation.