Instruction manual

Introduction
Page 14 Solution & Solution XL Operating Manual – Issue 1.0
Playback X Controls
Playback X (Memory) Master Fader
The MASTER fader controls the maximum output level of the memory being
output on the Playback X. This fader only affects the dimmer and brightness
fixture channels (if applicable). The Colour, Beamshape and Position fixture
channels are not affected by the master fader.
Go Button
The GO button is used to initiate a crossfade between the memory currently
being output and the Next memory in the memory stack as indicated on the
Memories screen.
Pause Button
The PAUSE button is used to pause a crossfade between the current and
next memories. When a crossfade has been paused, the red light in the
button flashes. Pressing the GO button releases the pause. Pressing Pause
again will step backwards in the cue stack.
Override Control
The OVERRIDE control is used to slow down or speed up the crossfade
between the current and next memory. When the control is moved away from
the central neutral position, this is indicated on the monitor screen.
Step Button
The STEP button is used to manually step through any chase memory with
manual drive currently being output on the Playback X.